high capacity load cell

Capacities above 100 kN (about 10 tons) are generally viewed as high, but in geotechnical work, we often supply sensors rated at 500 kN up to several MN. Selection starts with your maximum expected load plus a safety margin, usually 20-50%. Give our team the details of your test setup or structural monitoring plan, and we can recommend a model that balances over-capacity and resolution.

Most units feature welded construction and internal sealing that meet IP67 or higher, so they resist rain, dust, and temporary submersion. For long-term burial, we can add extra potting and specify stainless steel to avoid corrosion. The strain gauge circuit is temperature-compensated, which cuts down on drift when ground temperatures fluctuate.

Yes, customization is routine for us. Many projects need center-hole designs for anchor monitoring, low-profile pancake types for tight spaces, or custom adapters to match existing fixtures. Send us a sketch, and our engineers will propose a feasible configuration, often without a dramatic cost increase.

Our high capacity load cells are passive strain gauge devices, so they need a suitable amplifier or indicator. We can provide compatible handheld readouts, DIN-rail modules, or data loggers with RS-485/Modbus output. If you already have a measurement system, we’ll match the wiring and sensitivity (mV/V) to ensure plug-and-play compatibility.

We provide factory recalibration with traceable certificates. For active projects, an annual check is typical, but harsh environments or high-cycle loading might call for more frequent verification. We can also advise on on-site calibration methods using known weights or hydraulic jacks if shipping the unit back is impractical.